What should be prepared before installation?
Pre-install preparation covers wall flatness check, dimension confirmation and reserved installation position for commercial LED bathroom mirror hotel projects.
- Check wall surface flatness, with tolerance controlled within 3 mm; uneven tile surfaces will lead to mirror tilt and affect anti-fog function.
- Measure installation width and height twice to align with custom mirror dimensions before factory production.
- Mark the final installation position above bathroom countertops, leaving 8–12 mm drainage gap at mirror bottom.
- Evaluate bathroom ventilation; RH over 60% long-term humidity accelerates LED circuit aging for hotel guestroom mirrors.
What electrical provisions are needed?
Low-voltage power wiring must be pre-reserved; all electrical components must meet IP44 waterproof standard for damp bathroom commercial environments.
- Pre-run 12V DC low voltage wiring at the reserved mirror position; do not run high voltage directly inside wet shower zones.
- Confirm power cable routing before tiling work in new hotel construction; post-tile wiring modification will raise construction cost by 20–30%.
- Power adapters should be placed outside wet zones for easy replacement; avoid burying adapters fully inside wall cavities.
- Refer to our What Is an LED Bathroom Mirror? for full electrical planning.
Would you like to check commercial mirror wiring specifications before ordering?