What Is TOF Radar Sensing?
TOF stands for Time of Flight; TOF radar sensing calculates target distance by measuring electromagnetic signal round‑trip travel time and supports stable non‑contact human detection.
- TOF is short for Time of Flight, which is the core technical principle of radar interactive sensing hardware.
- It computes real‑time target distance by measuring time consumed for electromagnetic signal transmission and return.
- Distance measurement data is further used to identify object existence and human movement trajectory.
- This technical route perfectly adapts to touch‑free sensing requirement for Radar‑TOF Tech interactive floor screen commercial projects.
How Does the Radar Detect Human Movement?
TOF radar keeps scanning designated zones, captures distance changes caused by human movement, converts physical motion into digital data for the control system to trigger interactive effects.
- Radar hardware continuously performs full‑range scanning on pre‑defined interactive working zones.
- It identifies distance and position variation generated when people walk or move within detection scope.
- Raw physical sensing signals are converted into standardized digital data and sent to central control equipment.
- Interactive software analyzes data and executes corresponding pre‑configured LED visual response logics.
Where Is the Radar Sensor Installed?
TOF radar sensor is an independent overhead external unit rather than built‑inside floor tiles; ceiling‑mounted layout is mainstream for commercial interactive LED floor projects.
- Sensing hardware belongs to external independent component, not pressure sensor pre‑embedded inside each floor tile.
- Most real‑world projects adopt ceiling or overhead suspension installation mode.
- Actual sensor mounting position directly determines final effective sensing coverage boundary.
- Project designers must evaluate installation height and orientation at the early drawing‑design phase.
Why Use an External Radar Sensor?
External radar separates sensing hardware from LED floor modules, removes requirement to embed pressure sensors inside tiles and enables independent planning of sensing coverage vs display layout.
- Sensing hardware is placed outside LED floor tile mechanical structure without occupying tile internal space.
- No need to integrate pressure or capacitive sensing components in every single LED floor module.
- It greatly simplifies the whole interactive sensing system hardware architecture.
- Sensing‑area layout can be adjusted separately, without being completely restricted by LED display tile arrangement.
Check related article: What Is a Radar Interactive LED Floor Screen?